Hi,
first off I have to say that I am not sure if it is not the onboard wifi chip that is just faulty, but would hope to find this out with your help. Also, I am pretty much a linux noob, but I'll try my best to give you all the information you might need to better assess the problem than I can.
Since the beginning the driver of my wifi chip failed on occasion, leading to the wifi cutting off and the pc being unable to shutdown. Recently I get error messages on boot and neither wifi nor bluetooth are working or even showing in the OS. Here some outputs from some commands:
lspci (the adapter in question):
However, the device does not show up when I run nmcli, lsusb or ip link
The error messages I get on boot are the following (extracted from the journalctl):
Does anybody have any idea what I could try to get it up and running again or is the chip dead?
Thanks alredy!
first off I have to say that I am not sure if it is not the onboard wifi chip that is just faulty, but would hope to find this out with your help. Also, I am pretty much a linux noob, but I'll try my best to give you all the information you might need to better assess the problem than I can.
Since the beginning the driver of my wifi chip failed on occasion, leading to the wifi cutting off and the pc being unable to shutdown. Recently I get error messages on boot and neither wifi nor bluetooth are working or even showing in the OS. Here some outputs from some commands:
lspci (the adapter in question):
Code:
0a:00.0 Network controller: MEDIATEK Corp. MT7922 802.11ax PCI Express Wireless Network AdapterThe error messages I get on boot are the following (extracted from the journalctl):
Code:
kernel: hub 10-0:1.0: config failed, hub doesn't have any ports! (err -19)kernel: usb 3-12: device descriptor read/64, error -110kernel: usb 3-12: device descriptor read/64, error -110kernel: usb 3-12: new high-speed USB device number 5 using xhci_hcdkernel: usb 3-12: device descriptor read/64, error -110kernel: usb 3-12: device descriptor read/64, error -110kernel: usb usb3-port12: attempt power cyclekernel: usb 3-12: new high-speed USB device number 7 using xhci_hcdkernel: usb 3-12: Device not responding to setup address.kernel: usb 3-12: Device not responding to setup address.kernel: usb 3-12: device not accepting address 7, error -71kernel: usb 3-12: new high-speed USB device number 8 using xhci_hcdkernel: usb 3-12: Device not responding to setup address.kernel: usb 3-12: Device not responding to setup address.kernel: usb 3-12: device not accepting address 8, error -71kernel: usb usb3-port12: unable to enumerate USB devicekernel: mt7921e 0000:0a:00.0: driver own failedkernel: mt7921e: probe of 0000:0a:00.0 failed with error -5Thanks alredy!
Statistics: Posted by Moogie2 — 2024-05-13 10:26 — Replies 0 — Views 31